48V and 51.2V LiFePO4 packs from 56Ah to 105Ah for Club Car, EZGO and Yamaha fleets. 3,500 cycles at 80% depth of discharge, 1C charge acceptance between rounds, and the charger plus SOC meter supplied in the same kit instead of three separate purchase orders.
Request a QuoteFleet enquiries usually arrive with a number copied off the old lead-acid bank: 6 x 8V 170Ah, or 8 x 6V 225Ah. That number describes the lead-acid set. It says very little about the energy your carts actually consume, because a lead-acid bank can only give up about half of its rated capacity before the voltage sags and the controller cuts out. Lithium works on a different rule.
Convert both sides to usable kilowatt-hours before comparing. A 48V 170Ah lead-acid set is 8.16 kWh on paper and about 4.08 kWh usable at 50% depth of discharge. A 51.2V 105Ah LiFePO4 pack is 5.38 kWh on paper and about 4.57 kWh usable at 85% depth of discharge. The lithium pack is smaller, weighs a third as much, and still carries roughly 12% more usable energy than the bank it replaces. That is the whole argument, and it is arithmetic rather than marketing.
| Cart duty | Typical lead-acid set | Usable kWh | LiFePO4 replacement | Usable kWh |
|---|---|---|---|---|
| 2-seat utility, short loops | 6 x 8V 100Ah (48V) | 2.40 | 48V 56Ah | 2.44 |
| 4-seat, 18 holes, flat course | 6 x 8V 145Ah (48V) | 3.48 | 51.2V 105Ah | 4.57 |
| 4-seat, 18 holes, hilly course | 6 x 8V 170Ah (48V) | 4.08 | 51.2V 105Ah | 4.57 |
| 6-seat shuttle, resort loops | 8 x 6V 225Ah (48V) | 5.40 | 2 x 51.2V 105Ah in parallel | 9.14 |
Run the same arithmetic on your own fleet before ordering. Take the amp-hours of the set you run today, multiply by the pack voltage, halve it for lead-acid usable energy, then divide by 0.85 to find the lithium kilowatt-hours you need. If the answer lands between 2.4 and 4.6 kWh, one 105Ah pack covers it. Above 4.6 kWh, plan for two packs in parallel, and check that your cart bay has room for the second one.
Lead-acid chargers push roughly 25A into a 48V bank, and a lead-acid battery will not accept much more than that without damage. A full charge therefore takes five to eight hours, which is why courses charge overnight. A 105Ah LiFePO4 pack accepts 1C, so 105A, and will take that current happily in the middle of the day between tee times.
That only happens with a charger built for lithium. The old lead-acid unit finishes with a float stage that holds a constant voltage indefinitely, and LiFePO4 must not be held at float the way a flooded battery is. It needs a fixed cut-off at the pack absorption voltage and then nothing. This is the most common way a fleet damages a new lithium pack in its first month, and it is entirely avoidable.
So the kit we quote includes the charger matched to the pack, not just the battery. If you already own lithium-capable chargers, send the model and output voltage and we will confirm whether they can stay.
A lead-acid controller estimates state of charge from voltage. That works because a lead-acid bank sags steadily as it empties. LiFePO4 holds a flat 51.2V to 52V across most of its range, then falls away sharply at the end. A controller still reading voltage will believe a nearly empty lithium pack is nearly full, and the cart will stop without warning at the far end of the course.
Send those five items and we will reply with a pack recommendation, a charger match and a price for one unit, ten and fifty. Sample packs are available for a single cart before a fleet order. We would rather you test one cart for a month than commit a fleet on a datasheet.

24–48V custom packs for e-bikes, cargo bikes & scooters
View products →💬 WhatsApp48V and 51.2V LiFePO4 packs from 56Ah to 105Ah for Club Car, EZGO and Yamaha fleets. 3,500 cycles at 80% depth of discha…